Operation
Auto Test
Fan Mode
DMX Personality
DMX Control
This setting starts the products test sequence.
∙Go to the Auto Test main level.
This setting allows you to control the fan speed.
1.Go to the Fan Mode main level.
2.Select the desired speed (Low, High, or Auto).
∙When in AUTO, the fan speed automatically changes so the product’s temperature does not exceed the maximum allowed value.
∙When in the other settings, the fan speed follows the predefined values.
∙The internal controller will override any manual setting if the internal temperature rises above a certain level.
This setting allows you to choose a particular DMX personality.
1.Go to the Channel Mode main level.
2.Select the desired personality (15chan, 27chan, 31chan, or 34chan).
∙See the DMX Values section for the highest starting address you can select for each personality.
∙Make sure that the starting addresses on the various products do not overlap due to the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All products with the same starting address will respond in unison.
1.Select a DMX personality as shown in DMX Personality.
2.Set the starting address:
a.Go to the DMX Address main level.
b.Select the starting address
The highest recommended starting address for each DMX mode is as follows:
DMX Personality | DMX Address | DMX Personality | DMX Address |
15chan | 498 | 31chan | 482 |
27chan | 486 | 34chan | 479 |
Legend™ 412Z User Manual Rev. 1 |
