4.OPERATING INSTRUCTIONS
Configuring the Starting Address
The Abyss™ LED 2.0 fixture uses two DMX channels. The highest channel that the fixture may be set to in order to function properly is 511. Any address higher than this will prevent access to all of the channels.
If this is your first time using DMX, we recommend reading the “DMX Primer” section in the “Appendix”.
DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
Mode | DIP switches |
DMX | 1~9 = set to the DMX starting address |
| 10 = On |
Master/Slave Mode (Standalone)
This mode allows a single unit to auto change in Standalone Mode.
Turn switch to the Slave position on the slave units, and they will react the same as the Master.
The Master must be set to standalone mode.
Mode | DIP switches |
Slave | 1, 10 = On |
4. Operating Instructions | 8 | 11/10/2010 3:19 PM |
