Configuration
DMX Mode
Setting this product to operate in DMX mode will allow you to control it with a DMX controller.
1)Connect this product to a suitable power outlet.
2)Turn this product on.
3)Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket of this product.
Starting Address
When selecting a starting DMX address, you must always consider the number of DMX channels assigned to the selected DMX mode. If choose a starting address that is too high, you could limit the access to some of the channels of the DMX mode in use.
The Scorpion™ RVM/RGY/GVC uses up to nine DMX channels, which defines the highest configurable address to 504.
If you are not familiar with the DMX protocol, you may refer to the “DMX Primer” section in the “Technical Information” chapter.
To select the starting address, do the following:
1)Press <MENU> repeatedly until 001 shows on the display.
2)Press <ENT>.
3)Use <UP> or <DOWN> to select the starting address.
4)Press <ENT>.
Standalone Modes
Sound Mode
To enable the Sound mode, do the following:
1)Connect this product to a suitable power outlet.
2)Turn this product on.
3)Press <MENU> repeatedly until one of the following menu options appear on the display: So1, So2, So3, LSS.
4)Press <ENT>.
5)Turn the music on.
6)Press <MENU> repeatedly until S 0 ~ S 9 shows on the display.
7)Use <UP> or <DOWN> to select sensitivity level (low ~ high).
8)Press <ENT>.
The fixture will only respond to the low frequencies of the music (bass and drums).
Never connect a fixture that is operating in Static, Automatic, or Sound mode to a DMX string that is being controlled by a DMX controller because it may interfere with the signal from the controller.
Automatic Mode
To enable the Automatic Mode, follow the instructions below:
1)Connect this product to a suitable power outlet.
2)Turn this product on.
3)Press <MENU> repeatedly until one of the following menu options appear on the display: AF1, AF2, AF3, AS1, AS2, AS3, AFM, ASM.
4)Press <ENT>.
Never connect a fixture that is operating in Static, Automatic, or Sound mode to a DMX string that is being controlled by a DMX controller because it may interfere with the signal from the controller.
Scorpion™ RVM/RGY/GVC User Manual (Rev. 01e) | Page 15 of 24 |
