Tripod Stand

This fixture may be mounted on the included tripod stand.

1.Setup the Tripod stand on a sturdy platform that is capable of holding at least 10 times the weight of the stand with Mini 4BAR™.

2.Use the Tripod Legs Adjustment Knob to slide open the legs and set the tripod to a safe operating level.

3.Adjust the stand height to the minimum operating height level using the Height Adjustment Knob and the safety pin. The Safety Pin must be used.

4.Attach the Mini 4BAR™ to the tripod stand.

5.Using the Tripod Stand Securing Knob, hand-tighten the Mini 4BAR to the stand.

6.After confirming that the Safety Pin is removed, carefully and slowly loosen the Height Adjustment Knob to allow the height of the stand to be increased. The top of the stand may drop quickly, so be careful to control this and be aware of personal safety!

7.Raise the stand to the desired height and hand-tighten the Height Adjustment Knob. Then, insert the Safety Pin to secure the height of the stand.

8.Plug the fixture into power.

9.Plug the 3-pin footswitch into the fixture for control.

There is a safety pin included, which MUST be used. There are 6 positions that this stand may be set to, and 6 holes to attach the safety pin. After the 6th position, there will be a warning sign that says “STOP!” Do not move the stand height past this point!

Height Adjustment Knob

Safety Pin

Tripod Legs Adjustment Knob

5. Appendix

9

5/7/2010 1:21 PM

Page 9
Image 9
Chauvet Work Light user manual Tripod Stand