![](/images/new-backgrounds/1040715/4071529x1.webp)
FIGURE K
PIN (51) | |
(52) |
RAIL (35)
PIN (51)
PACKAGING
MATERIAL
13.Position the Garage Door Opener on the garage floor below the unit’s previously installed Header Bracket (54). Use product packaging material to protect the Housing (31). Raise the Rail (35) until the two holes at the end of the Rail align with the two holes in the Header Bracket. Secure the Rail to the Header Bracket using a Pin (57). Insert an
(See Figure K.)
Note: To enable the Rail to clear sectional door springs, it may be necessary to lift the Garage Door Opener onto a temporary support. The Garage Door Opener must be secured to a support or held firmly in place by another person.
FIGURE L
1”
BOARD
14.A 1” thick board is ideal for setting the proper
Rail on the board. NOTE: If the raised garage door hits the unit’s Trolley (45), pull down on the Trolley Release Arm to disconnect the inner and outer Trolley sec-
SKU 65712 | For technical questions, please call | Page 15 |