MUST be replaced by a qualified ser- vice technician.
11.People with pacemakers should consult their physician(s) before use.
Electromagnetic fields in close prox- imity to heart pacemaker could cause pacemaker interference or pacemak- er failure. In addition, people with pacemakers should:
•Avoid operating alone.
•Do not use with power switch locked on.
•Properly maintain and inspect to avoid electrical shock.
•Any power cord must be properly grounded. Ground Fault Circuit Inter- rupter (GFCI) should also be imple- mented – it prevents sustained elec- trical shock.
12.WARNING: Handling the Power Cord on this product will expose you to lead, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling. (California Health & Safety Code § 25249.5, et seq.)
13.The warnings, precautions, and in- structions discussed in this instruction manual cannot cover all possible con- ditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Save these instructions.
Grounding
To prevent electric shock
and death from incorrect grounding wire connection: Check with a qualified electrician if you are in doubt as to whether the Outlet is properly grounded. Do not modify the Power Cord Plug provided with the equipment. Never remove the grounding prong from the Plug. Do not use the equipment if the Power Cord or Plug is damaged. If damaged, have it repaired by a service facility before use. If the Plug will not fit the Outlet, have a proper Outlet installed by a qualified electrician.
Double Insulated Tools: Tools
with Two Prong Plugs
1.Equipment marked “Double Insu- lated” do not require grounding. They have a special double insulation system which satisfies OSHA require- ments and complies with the applica- ble standards of Underwriters Labo- ratories, Inc., the Canadian Standard Association, and the National Electri-
SKU 65712 | For technical questions, please call | Page 6 |
