Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
|
| TO PREVENT SERIOUS INJURY |
|
| |
|
| FROM FLYING FRAGMENTS: |
TO PREVENT SERIOUS INJURY FROM | Do not use blades made from | |
ACCIDENTAL OPERATION: | abrasive blades, or metal- or | |
Release the Trigger, turn off the laser and | The guards of this saw are not designed to | |
unplug the tool from its electrical outlet before | protect against the failure of such blades. | |
adjusting tool or installing accessories. |
| |
To Remove/Install A Saw Blade (sold separately):
| Spindle |
1. Lower the Base Plate to its lowest setting | Lock Lever |
(See Depth Adjustment, following). |
|
2.Depress the Spindle Lock Lever to hold the Saw Blade in place and unscrew (counterclockwise) and
remove the Blade Clamp Bolt and Outer Flange. | Lower |
|
|
|
|
| |
3. Pull the Lower Guard all the way up into the | Guard |
|
|
Lever |
|
| |
Upper Guard. Remove the old Saw Blade and |
|
| |
|
|
| |
install a new Saw Blade onto the Shaft. | Outer |
|
|
Note: Make sure to install the new Saw Blade with its |
|
| |
Flange |
|
| |
teeth and the arrow on the Saw Blade pointing in the | Blade Clamp Bolt | Base | |
same direction as the arrow on the Lower Guard. |
| ||
Depth Adjustment | Figure 2 | Saw Blade | Lower Guard |
| |||
1.Loosen the Depth Lever.
2.Hold the Base down with one hand and raise or lower the body of the Saw with the other hand until the Blade is at the desired Depth of cut, using the Depth Gauge as a guide.
3. Tighten in place with the Depth Lever. |
| Depth Lever |
WARNING! To reduce the risk of Serious Injury: | Base | Depth Gauge |
|
| |
Depth of cut must be adjusted to just clear the workpiece. | Figure 3 | Lower Guard |
SAFETY
SETUP
OPERATION
Angle Adjustment
1.Loosen the Angle Lock Knob.
2.Adjust the Base to the desired angle between 0° and 45°, using the Angle Gauge as a guide.
3.Tighten in place with the Angle Lock Knob.
Fence Adjustment
1. | Loosen the Fence Lock Knob. |
2. | With the main guide of the Fence facing downward, |
| slide the bar of the Fence into the slots on the Base |
| until it is the desired distance from the Blade. |
Figure 4
Fence
Main
guide of
Angle Lock
Knob
Angle
Gauge
Base
Bar of Fence
MAINTENANCE
3. Tighten in place with the Fence Lock Knob. |
Fence
Fence Lock
Knob
Figure 5
Item 69078 | For technical questions, please call |
Page 11
