Page 11For technical questions, please call 1-800-444-3353.Item 69231
SAFETYOPERATIONMAINTENANCE SETUP
Positioning the Miter Guide
Place the Miter Guide against the Rip Fence.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard
or exposing the power cord to possible damage.
The power cord must reach the work area with
enough extra length to allow for a drip loop.
3. Make sure that the Base is on a steady level
work surface so the water level of the tank can
be accurately measured and maintained.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Keep workpieces pressed firmly against
the Table and Fence while cutting.
6. Mark cut lines using waterproof marker or crayon.
General Operating Instructions
1. Install the Blade and check that the Upper
and Lower Blade Gaurds are in place.
2. Fill the Water Tray to the Maximum Fill
line on the sides of the Tray and slide it
under the Lower Blade Guard, raising
the tool slightly to allow the Water Tray
to fit. Check that the water level is
between the MIN and MAX on the Lower
Blade Guard and adjust if needed.
CAUTION: Do not operate the Tile
Saw with too little or too much water in
the Water Tank. Keep the water level
between the minimum and maximum level
markings on the Lower Blade Guard.
Figure G
Water Tray
Lower
Blade
Guard
MIN
MAX