Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Charge the Battery Pack (18) and insert it in the tool, as described in the previous section.
2.Select an appropriate bit or attachment for the job. Insert the bit or attachment as described in the previous section.
3.The LED Lighted Collar light may be turned on by moving the switch on the collar.
7.Store the tool, its battery, and its bits and attachments in their case in a safe location.
8.Dispose of used batteries properly. Consult your local hazardous waste authority for disposal guidelines.
Figure 10
4.Rotate the Switch (8) to the ON position. NOTE: This is a variable speed switch. The tool bit speed is dependent on the position of the Switch. Use a speed appropriate to the bit and the material being worked on. In general, harder materials require faster speeds and softer materials require slower speeds. Relative speeds are indicated by the numbers on the Switch.
5.Apply the tool bit to the work material as needed.
6.When the task has been completed, stop the tool by rotating the Switch (8) to the
OFF (“O”) position. If the LED Collar light is ON, switch it OFF. Unplug the rechargeable battery. Remove the bit or attachment as discussed in the previous section.
Page 12 | For technical questions, please call | SKU 92880 |
