5.You must use personal safety equipment including, but not limited to, ANSI- approved eye and hearing protection, as well as heavy work gloves.
6.Before beginning work, provide for sparks and debris that will fly off the work surface. CAUTION: Always have access to a type AAA fire extinguisher.
use, possibly causing injury. Allow the bit time to cool before handling it.
3.To remove a bit: Pull the bit straight out of the Collet once the Collet Nut is loose. To insert a bit: Insert the shank end if the bit into the Collet once the Collet Nut is loose.
Collet Nut | Collets |
Set-Up
Inserting a Bit in the Tool
Note: Only use accessories that are rated at or above the RPM rating of the Cordless Rotary Tool.
WARNING: Always allow the motor to come to a complete stop before engaging the spindle lock.
WARNING: Always remove the battery pack before making any adjustments or changing bits, to prevent accidental starting of the tool. Accidental starting of the tool may result in serious personal or property injury.
Figure 10
1.Depress the Spindle Lock (10). Rotate collet until shaft is engaged by the lock.
2.Loosen the Collet Nut (1) by turning it counterclockwise, using the Wrench provided.
WARNING: If you are changing a bit immediately after use, be careful not to touch the bit. It may be very hot from
Figure 10
NOTE: Your tool is provided with two collets, 1/8” and 3/32” diameter. These are precision manufactured to fit comparably sized bits. Do not force a bit into the wrong sized collet, and do not modify a mismatched collet or bit.
Severe personal or property damage may result from using mismatched collets or bits.
4.Tighten Collet Nut securely using the provided wrench. Ensure that the spindle lock is released before turning on the tool.
WARNING: Be sure the Collet Nut is tight before turning on the tool. Bits may be ejected from a tool if the Collet Nut is loose, potentially causing severe personal or property damage.
Installing the Flexible Shaft
2.Be sure that the Rotary Tool is turned OFF (the “O” position), and that the Battery is removed from the Handle before attaching the Flexible Shaft Attachment (26).
3.Remove any bits that might be installed.
Remove the Collet Lock Nut and the
Collet.
4.Remove the Collar or LED Collar from the tool Body by turning it counterclockwise.
REV 10e
Page 10 | For technical questions, please call | SKU 92880 |
