Specifications
| ||
Construction | Housing, Brass Spindle & | |
Collets, Stainless Chuck | ||
| ||
| Body | |
Power Required | 9.6 VDC / NiCd Battery | |
Pack | ||
| ||
Battery Recharge | 120 VAC to 12 VDC | |
Transformer | ||
| ||
Tool Speed | Variable: | |
5,000 - 25,000 RPM | ||
| ||
LED Source | (2) | |
Features | Variable Speed, | |
LED Light Attachment | ||
|
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
When unpacking, check to make sure the following parts are included:
9.6V Rotary Tool w/Battery
Shaft Mounted LED Light Attachment AC/DC Transformer
9.6V Battery Charger Base
Flat Wrench
Square Stone Dresser
Plastic Carrying Case
Figure 1
Charging the Battery Pack
Battery packs are normally shipped with low or no charge to prevent potential problems during shipment. Before use, you must charge your new battery pack.
Figure 2
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) before the battery will become fully charged.
WARNING: Battery explosion may cause serious personal or property injury including death. Charge the battery only within a 50° to 100° temperature range. Lower temperatures may inhibit charging. Higher temperatures increase chance of battery failure, including explosion.
1.Charge the battery pack only with the included Charger Base (25). Use of other chargers may cause battery failure including explosion.
2.Ensure that the Charger Base (25) is connected to a circuit breaker protected 120 VAC, 60 Hz power supply only.
3.Connect the Charger Base to the Transformer (24), by plugging it in as shown in Figure 2. Plug the Transformer (24) into a 120 VAC wall outlet.
REV 10e
Page 8 | For technical questions, please call | SKU 92880 |