4.Insert the battery pack into the Charger Base (25) by aligning the ribs on the Charger Base with the grooves in the battery pack. Press the battery pack into place.
6.Press down on the battery pack to make sure that the contacts on the battery pack are fully engaged with the contacts in the charger unit.
7.While being charged, the green LED will be lit, indicating that the charger is in operation. During recharging, the battery pack will become slightly warm to the touch. This is normal and not a cause for concern.
8.Do not place the battery and charger in an environment of extreme heat or cold. They will work best at room temperature.
9.Note: The Charger Base (25) will not shut off automatically. When the battery is fully charged (after 3 to
Installing the Battery Pack
1.Place the battery pack in the tool, aligning the arrows on the battery pack with the arrows on the tool.
2.Press the battery pack into the tool. Make sure that the battery pack snaps into place, and that the battery pack is secure in the tool before beginning use.
Removing the Battery Pack
1.Press the Release Tabs (19) on both sides of the battery pack to release the battery from the tool.
2.Remove the battery pack from the tool by pulling straight out.
REV 10e
Instructions for putting
into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and remove the Battery Pack before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
SKU 92880 | For technical questions, please call | Page 9 |
