Technical
Specifications
|
|
| Four Stroke Single | |
Engine Type |
| Cylinder OHV Diesel, | ||
|
|
| 10HP | |
Bore x Stroke | 86x72 mm | |||
Compression Ratio | 19±:1 | |||
Displacement | 418 cc | |||
Rotation viewed from PTO | Counterclockwise | |||
(power takeoff - the output shaft) | ||||
| ||||
Fuel |
| Type | #2 Diesel Fuel | |
| Capacity | 4.2 Gallons | ||
|
| |||
Engine Oil |
| Type | ||
| Capacity | |||
|
| |||
Valve |
| Intake | 0.10~0.15 mm | |
Clearance |
| Exhaust | 0.10~0.15 mm | |
(COLD) |
|
|
| |
Speed |
| Idle | 1,100 RPM | |
| Maximum | 3,600 RPM | ||
|
|
The emission control system for this Generator’s Engine is warranted for standards set by the U.S. Environmental Protection Agency. For warranty information, refer to the last pages of this manual.
Servicing
To prevent serious injury
from accidental starting:
Turn the Power Switch of the equipment to its “OFF” position, wait for the engine to cool before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury
from equipment failure: Do not use damaged equipment. If abnormal noise, vibration, or excess smoking occurs, have the problem corrected before further use.
Maintenance Procedures
Many maintenance procedures, including those not detailed in this manual, will need to
be performed by a qualified technician for safety. If you have any doubts about your ability to safely service the equipment or engine, have a qualified technician service the equipment instead.
Note: Warranty is void if proper mainte- nance and servicing procedures are not followed.
Engine Oil Change
CAUTION! Oil is very hot during opera- tion and can cause burns. Wait for engine to cool before changing oil.
1.Place a drain pan (not included) un- derneath the crankcase’s drain plug.
2.Remove the drain plug and empty oil. Recycle used oil.
3.Inspect drain plug gasket for damage or tears. Replace gasket if damaged. Replace the drain plug and tighten it.
4.Refill the oil to the proper level follow- ing the instructions under the Starting the Engine section.
REV 09a
SKU 98391 | For technical questions, please call | Page 16 |