Symbology
CHARGING & USING BATTERY PACKS
Volts Direct Current
Impacts per Minute
Under Load (IPM)
Properly Recycle Nickel
Cadmium Batteries
Underwriters
Laboratories, Inc.
No Load Revolutions per Minute (RPM)
Specifications
Cat. |
|
|
| Drive |
| Average |
| Volts |
|
| Torque | ||
No. | Type | DC | RPM | Shank | IPM | Output |
CP 8730 | Impact Wrench | 14.4 | 0 - 2600 | 3/8" Square | 0 - 3500 | 1056 |
CP 8740 | Impact Wrench | 14.4 | 0 - 2600 | 1/2" Square | 0 - 3500 | 1404 |
FUNCTIONALDESCRIPTION
Cat. No. CP 8730
1
1.3/8" square drive shank
2.Forward/reverse switch
3.Trigger
4. | Battery pack | 2 | |
| |||
5. | Battery pack release button | 3 | |
6. | 1/2" square drive shank | ||
|
6 | 4 |
5
Cat. No. CP8740
WARNING!
Charge only Chicago Pneumatic 9.6V, 12V, 14.4V, 18V battery packs in chargers. Other types of batter- ies may explode causing personal injury and damage.
Charge your battery pack before using your tool for the first time and when your tool no longer performs with the power and torque needed for the job. Full loading capacity of battery pack is only reached after 4 - 5 chargings. Never completely dis- charge the battery pack. Standard charg- ing time will vary according to the type of charger you use. The charging time will also vary depending on the supply voltage and charge needed. For example, if your battery pack does not require a full charge, charging time will be less.
FOR SPECIFIC CHARGING INSTRUCTIONS, PLEASE READ THE CHARGER INSTRUC- TION SHEET SUPPLIED WITH YOUR CHARGER.
Battery packs are affected by tempera- ture. Your battery pack will perform best and have longest life if it is charged when the temperature is between
Removing Battery Pack from Tool
Push in the release buttons and remove the battery pack.
Inserting Battery Pack into Tool
Battery pack can be inserted into the tool in two ways.
1.For working in restricted spaces.
Insert the battery pack from the front by pressing in the release buttons and sliding battery pack into the body of the tool (Fig. 1). Insert the battery pack until clamp engages.
Fig. 1
2.For optimum weight distribution and balance.
Insert the battery pack from the back by pressing in the release buttons and sliding the battery pack into the body of the tool (Fig. 2). Insert the battery pack until clamp engages.
Fig. 2
4 | 5 |
