KSY220 | Installation Instructions |
| (J) X 2 |
| (M) X 2 |
| 4 |
| (K) X 4 |
| 1 |
| (L) X 2 |
| (A) X 2 |
| 3 |
| (N) X 2 |
| 2 |
| (P) X 2 |
Figure 4
Display Installation
The mounting holes on the back of the display will be flush with the back surface, or recessed into the back. Refer to the applicable installation procedure below.
Flush Mount Display Installation
CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL
in the previous step) with the two top teardrop mounting holes on the Centris cup.
CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Smaller area of teardrop mounting holes must be facing downward for proper installation. Reposition Centris cup if required.
INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display! Proper screws will easily and completely thread into display mounting holes.
CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread engagement in display may cause display to fall! Back out screws ONLY as necessary to allow installation of Centris bracket!
1.Ensure Centris cup is able to swivel and tilt easily, yet still be tight enough to hold display in desired position. Adjust as required before proceeding. See "ADJUSTMENT" for detail.
(Q3) x 2 |
2 |
3 |
Centris Cup |
2.Using Phillips screwdriver, carefully install two screws (Q3) into the upper mounting holes on the display. Thread screws completely into display, then back out 3 complete turns.
3.Align two screws (Q3) (installed on the back of the display
Figure 5
4.Using Phillips screwdriver, install two screws (Q3) through the lower mounting holes in Centris cup into the display.
5.Tighten all screws (Q3). Do not overtighten!
6