Installation Instructions | KSY220 | |
| Centris Cup |
|
| Centris Cup |
|
| 7 | (Q4 or Q5) |
|
| (4 places) |
| 4 |
|
| (Q3) x 2 | (Q1 or Q2) |
| 5 | (4 places) |
| Figure 6 |
|
6. Repeat display installation procedures for second display. |
| |
7. | Proceed to "CABLE MANAGEMENT." |
|
Recessed Mount Display Installation
1. Ensure Centris bracket is able to swivel and tilt easily, yet still be tight enough to hold display in desired position. Adjust as required before proceeding. See "ADJUSTMENT" for detail.
2. Carefully place display face down on a clean and dry surface.
3. Determine depth of recessed mounting holes relative to back surface of display.
4. Select proper length spacer and screw from table below: IMPORTANT ! : All spacers used should be the same length. If the recess depths result in multiple spacer lengths, then select the longer spacer.
| IF recess DEPTH is: | THEN use spacer: | AND screw: | |
|
|
|
| |
| 3/8" or less | Q1 (3/8" long) | Q4 (M4 x 20mm) | |
|
|
|
| |
| More than 3/8" up to | Q2 (3/4" long) | Q5 (M4 x 30mm) | |
| and including 3/4" |
|
| |
|
|
|
|
|
5. | Place the four spacers (Q1 or Q2) over each mounting hole | |||
|
| on the back of display. (See Figure 7) |
| |
6. | Orient mount so that mounting holes in the Centris cup are | |||
|
| aligned with the holes in the spacers (Q1 or Q2); rotate the | ||
|
| Centris cup as required (See Figure 7). | ||
CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display! Proper screws will easily and completely thread into display mounting holes.
7.Using Phillips screwdriver, install four screws (Q4 or Q5) through the mounting holes in Centris cup, through the spacers (Q1 or Q2), into display (See Figure 7).
8.Tighten all four screws. Do not overtighten!
9.Return to mount installation section to continue.
10.Repeat display installation procedure for second display.
Figure 7
Cable Management
1.Attach all cables to display.
2.Open the cable management bracket by sliding it towards the edge of the arm (See Figure 8).
NOTE: If necessary, cable management bracket attach screws may be loosened using hex key.
| Attach |
| Screws |
OPEN Position | CLOSED Position |
View from Bottom | |
Figure 8
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched when bracket is closed.
3.Carefully insert cables into bracket (See Figure 9).
7
