Installation Instructions | KSY220 | ||
INSTALLATION |
| ||
|
| (C) X 1 | |
| WARNING: FAILURE TO PROVIDE ADEQUATE |
| |
| STRUCTURAL STRENGTH FOR THIS COMPONENT CAN |
| |
| RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE |
| |
| TO EQUIPMENT! It is the installer’s responsibility to make |
| |
| sure the structure to which this component is attached can |
| |
| support five times the combined weight of all equipment. |
| |
| Reinforce the structure as required before installing the |
| |
| component. |
| |
OFBU and Wall Plate Installation |
| ||
1. | Install OFBU (C) following the instructions provided with the |
| |
| OFBU (C). | 3 | |
IMPORTANT ! : If the display being installed has a recessed | |||
| |||
mounting surface, the display must be assembled to the mount | (B) X 1 | ||
prior to mount installation. See Display Installation in this |
| ||
document before proceeding. |
|
2. Insert top of wall plate (B) over lip on top of OFBU bracket |
| Figure 2 |
(C). (See Figure 1) | 4. | Tighten set screw using 5/32" hex key (E). (See Figure 3) |
|
(C) X 1 |
2 |
(B) X 1 |
Figure 1
3.Swing wall plate(B) downward until flush against OFBU bracket (C). (See Figure 2)
CAUTION: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Make sure set screw engages back side of mounting dish on OFBU bracket
(C). (See Figure 3)
(C) X 1 |
(B) X 1 |
4 |
Figure 3
Swing Arm Installation
1.Insert pivot pin (N) into
2.Install spacer (L). (See Figure 4)
3.Insert arm assembly (A) on pivot pin (N).
4.While holding nut (P) in lower bore of
5.Loosely install screw (J) using 3/16" hex key (F).
6.Repeat Steps 1. through 5. for second mount arm assembly
(A).
5