<Note>
When Track Down is “ON,” the REC TRK switches are disabled. Also, if the Auto Bounce button or Track Down button is switched on and off while any one REC TRK switch is set to REC READY state, the selected REC TRK switch will be canceled. In this case, reselect the recording track using with the REC TRK switch.
8.While playing the synthesizer, gradually raise the channel 1 input/playback level fader.
As the fader is raised, the level meter 1 will start to blink.
Adjust the recording level by raising the input/ playback level fader to a point where the meter [3] blinks at maximum sound volume.
9.You can adjust the headphone or monitor speaker sound volume by turning the MONITOR knob, and the channel 1 MON MIX/ AUX knob.
10.Use the EQ knobs on channel 1 to adjust the tone.
11.Position the monitor sound image using the channel 1 PAN knob.
<Note>
If you had selected a track other than track 1 as the recording destination, use the MON MIX/AUX knob and PAN knob of the corresponding track channel. For example, if the sound source is input at LINE IN/INSERT 1 and to be recorded to track 2, use the MON MIX/AUX knob and the PAN knob on channel 2.
12.After adjusting the recording level and tone, press the REC button (the PLAY button will also depress) to start recording.
The REC indicator lights up in red.
13.When you finish recording, press the STOP button.
Recording will be canceled (the REC indicator turns off).
14.Press REC TRK switch 1 repeatedly to turn off the record track indicator.
15.Press the REW button and rewind the tape to counter [000].
Try recording on tracks 2-4 in the same way.
Model
13
