Installation Instructions | MSS6000 |
INSTALLATION
Mount Installation
Free Standing (not anchored) Applications Only:
NOTE: Do not perform this step if you are going to anchor the stand to a surface.
1.Install five rubber bumpers (B) on bottom of stand. (See Figure 1)
Rubber Bumpers |
(5 places) |
View from Bottom |
Figure 1
Display 24 Inches High or Smaller:
1.Loosen the four height adjustment screws and raise the slide to its maximum height. (See Figure 2)
2.Secure the slide by tightening the four height adjustment screws.
Faceplate Height Adjustment Screws (4) |
Figure 2
Display More Than 24 Inches High:
NOTE: The MSS6000 comes
1.Remove slide plate assembly from the base by removing four
1 | x 4 |
4 | x 4 |
| x 4 |
| Base |
| Assembly |
Slide |
|
Plate |
|
Assembly |
|
Figure 3
2.Remove face plate from slide plate assembly by removing two
3.Reinstall face plate into upper mounting holes of slide plate using two
4.Reinstall slide plate assembly onto base using four
5.Raise slide plate assembly to maximum height.
6.Secure slide plate in place by tightening the four height adjustment screws. (See Figure 2)
| Slide |
Face | Plate |
Plate | Lock |
| |
| Nut |
| Flat |
| Washer |
| Spacer |
Carriage Bolt |
|
Figure 4
5