Installation Instructions | MSS6000 | |
Display Swivel Tension Adjustment |
| |
Display swivel tension is |
| |
will vary depending on the weight of display being mounted. |
| |
If swivel tension adjustment is required: |
| |
1. | Disconnect all cords and cables from display. |
|
2. | Follow steps in Removing Display from Mount section. |
|
3. | Lay mount on back. (See Figure 11) |
|
4. | Locate three tension adjustment screws. (See Figure 11) |
|
5. | Turn each adjustment screw either clockwise to increase | 35° |
| tension, or | 15° |
NOTE: It is important that all adjustment screws are turned |
| |
| equal amounts in the same direction for the display to |
|
| turn properly. |
|
|
| 25° |
| Tension Adjustment Screw |
|
(Turn left to decrease tension | Figure 12 | |
Turn right to increase tension) | ||
|
Cable Management
|
| The MSS6000 has been designed to provide multiple cable |
|
| management/routing options. |
|
| Option A |
|
| Option A does not use the cable access features of the |
|
| MSS6000 and simply routes the cables away from the display |
|
| and mount. (See Figure ) |
| Figure 11 |
|
6. Install display following the instruction outlined in Display |
| |
| Installation section. |
|
7. | Test display swivel tension by grasping each side of display |
|
| and turning display left and right. |
|
If additional swivel tension adjustment is required, repeat steps |
| |
1 through 7 above. |
| |
Display Swivel Stop Location Adjustment |
| |
The MSS6000 allows for the installation of swivel stops that | Cable | |
limit the amount of display travel. Stops can be installed at +/- | ||
15°, 25° or 35°. | Access |
1.Follow steps 1 through 3 of Display Swivel Tension
Adjustment section. | Figure 13 |
2.Insert one
9