MSS6000 | Installation Instructions |
Site Preparation for Mounting to Surface
WARNING: EXCEEDING WEIGHT CAPACITY CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the combined weight of all components does not exceed 150 lbs (68.04 kg).
CAUTION: TURNING DISPLAY CAN CAUSE DAMAGE TO SURROUNDING OBJECTS. Make certain location provides enough area for the display to rotate + 45° without being obstructed.
NOTE: See Display Swivel Stop Location Adjustment
section for information on adjusting rotation.
1.Locate a flat dry surface on which to mount the MSS6000 assembly.
2.Measure the hole locations on bottom of MSS6000 and mark the four mounting hole locations on mounting surface. (See Figure 5)
| 2 | x 4 |
| 3 | x 4 |
| 1 |
|
|
| MSS6000 |
4 | x 4 | 3/4" |
| ||
|
| A |
Figure 5
3.Drill four 1/4" diameter holes through mounting surface at marks.
4.Secure mount to mounting surface using four
Display Installation
The following procedure assumes that the proper interface bracket for the display being mounted has already been installed on the display.
If no interface bracket is present on display, install bracket to display using the instructions included with the interface bracket before proceeding.
If an interface bracket for the display being mounted needs to be obtained, or additional assistance is required, contact a Chief Customer Service representative.
NOTE: If the display being mounted has a height of more than 24" the mount needs to be modified prior to display installation. (See Display More Than 24 Inches High section.)
To install the display:
1.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in faceplate. (See Figures 6 & 7)
1 |
Figure 6
2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes. (See Figures 6 & 7)
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 7)
6
