Chief Manufacturing MWC Series installation instructions Tilt Lock, Tilt Adjustment, Closed

Model: MWC Series Installation Instructions

NOTE: If Q-Latch does not fully close, ensure mounting buttons are fully seated in the button openings.

NOTE: A hole is provided in both the Q-Latch and the front plate to accommodate the insertion of a padlock or similar locking device.

NOTE: Display and interface not shown for clarity.

Locking device installed here

Q-Latch

TILT LOCK

1. If desired, the display may be locked at 0°, 5°, or 10°.

NOTE: A positive stop exists at 15° without the use of an additional locking screw.

•Slightly loosen the upper front plate attach screws. Do NOT remove screws.

•Using key (60), loosely install screws (40) through the slot in the front plate, through the applicable open tilt lock hole in the side plate, into nut (50)

(See Figure 11)(See Figure 12).

•Tilt display until lock is reached.

•Tighten all four screws (upper front plate attach, and 40).

Tilt lock holes (Right side shown; left side similar)

CLOSED

Figure 9: Close Q-Latch

WARNING: Make sure the latch securing the display is fully closed at all times except when removing or installing the display. The latch must be fully closed when installing or removing cables from the display.

5. Attach all cables to display and CPU.

Upper front plate attach screws

(Right side shown; left side similar)

10° 5° 0°

Figure 11: Tilt Lock Holes

TILT ADJUSTMENT

1.If desired, the display may be tilted to any position between 0° and 15°.

•Slightly loosen upper front plate attach screws (See Figure 10). Do NOT remove screws.

•Tilt display to desired angle.

•Tighten upper attach screws.

Upper front plate attach screws (2 places)

NOTE: Display shown at 15° position.

Figure 10: Tilt Adjustment

50 (2 places)

40 (2 places)

Side plate

Front plate

Figure 12: Tilt Lock Screw Installation

6