Installation Instructions | PNR Series |
Mounting the Display
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Displays can weigh in excess of 40 lbs (18.1kg). ALWAYS use two people and proper lifting techniques when installing display.
1.Install PSBU interface bracket (K - included with PNRU only) to display using hardware and installation instructions included with PSBU bracket.
2.Move faceplate to extended position by grasping faceplate and pulling outward away from wall.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
To use as a
more permanent 
lock, remove pin 
and nuts and move
to lower holes.
3
4
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make sure mounting buttons on display are properly seated in mounting holes in faceplate.
3.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in faceplate. (See Figure 6) and (See Figure 7)
4.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes and ClickConnect mechanism engages. (See Figure 6) and (See Figure 7)
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 7)
3 |
4 |
Figure 6
padlock or bolt may be
placed through latch holes.
Figure 7
9
