PNRIW / PNRIWU | Installation Instructions |
Installation
The following procedure assumes that a Chief Model PAC501
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! DO NOT deviate from installation instructions provided. DO NOT substitute hardware.
1.Align mounting holes in swing arm UPPER and LOWER mounting brackets with four mounting holes in PAC501. (See Figure 2)
Upper Mounting Bracket |
1 |
1 |
Lower Mounting Bracket |
1 |
Figure 2
2.Secure swing arm to PAC501 using four button head cap screws (C), four lock washers (D) and four flat washers (E). (See Figure 3)
2 |
(E) x4 |
(D) x4 |
(C) x4 |
Figure 3
Trim Installation
To install optional trim;
1.Remove paper covering adhesive and affix three tape squares (F) to inside lower flange of each trim piece (B). (See Figure 4)
2.Orient trim pieces (B) as shown in figure below. (See Figure 4)
3.Remove paper covering adhesive back from tape squares
(F) on trim and press trim (B) against inner wall of box. (See Figure 4)
(B) x 4
2
3
1(F) x 12
Figure 4
4