IBM 220 manual bracket assembly in a safe place

bracket assembly in a safe place.

4.Lift the release lever and remove the terminator card from the microprocessor connector.

5.Install the microprocessor:

a.Touch the static-protective package containing the new microprocessor to any unpainted metal surface on the server; then, remove the microprocessor from the package.

b.Orient the microprocessor over the microprocessor connector, as shown in the following illustration. Carefully press the microprocessor into the connector.

Microprocessor 2 connector

Terminator card

Microprocessor 2

Lever

Microprocessor orientation indicator

Attention: To avoid bending the pins, do not use excessive force when pressing the microprocessor into the connector.

6.Push the release lever down to lock the microprocessor into place.

7.If you are installing a microprocessor that has a speed of 933 MHz or higher, continue with step 9 on page 57.

If you are installing a microprocessor that has a speed lower than 933 MHz, continue with step 8 on page 56.

Chapter 5. Installing options 55