IBM 220 manual Review “Before you begin” on page

Note: The hard disk drive activity light and hard disk drive status light on the backplane match the hard disk drive activity light and hard disk drive status light on the hot-swap drive.

The following illustration shows the rear connectors on the hot-swap-drive backplane, as viewed from the rear of the server.

SCSI cable connector

SCSI power cable connector

I2C cable connector

The following illustration shows how to install a hot-swap hard disk drive in the server. When you install hot-swap hard disk drives, install them in the following order: bay 7, bay 6, and bay 5.

Filler panel

Drive tray assembly

Drive tray handle (in open position)

Attention:

•When you handle electrostatic discharge (ESD) sensitive devices, take precautions to avoid damage from static electricity. For details on handling these devices, see “Handling static-sensitive devices” on page 31.

•To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each bay.

To install a hot-swap hard disk drive in bay 5, 6, or 7, do the following:

1.Review “Before you begin” on page 31.

2.Read the information in “Preinstallation steps (all bays)” on page 45.

50 IBM® xSeries 220 User’s Reference