PTS SERIES

Installation Instructions

DISCLAIMER

CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

IMPORTANT WARNINGS AND CAUTIONS!

WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions.

WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided.

WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.

WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components located between the supporting structure and mount up to (and including) the display does not exceed

100 lbs (45.36 kg).

DIMENSIONS

[276]

10.86[176]

6.92

[114]

4.50

[606]

23.88

[360 +50.80]

14.17 +2.0

NOTE: CUSTOM INTERFACE BRACKET NOT SHOWN. THE CUSTOM INTERFACE BRACKET NEEDED FOR YOUR DISPLAY WILL ADD BETWEEN ½”AND 2” IN DEPTH AND MAY AFFECT LOCATION OF DISPLAY ON THE MOUNT.

MEASUREMENTS IN: [MILLIMETERS]

INCHES

[102]

4.00

[581]

22.88

WEIGHT CAPACITY:

100 LBS

HEIGHT ADJUSTMENT: 4” IN 1” INCREMENTS

TILT/ROLL:

+0°/ +2.5°

TO APPROX.

CENTER OF SCREEN

[18]

.70

2

Page 2
Image 2
Chief Manufacturing PTS Series installation instructions Disclaimer, Important Warnings and Cautions, Dimensions