Chief Manufacturing Rough Alignment of RPMA1, PITCH Adjustment, Adjustments, RPMA1, -B1, -C1

Installation Instructions RPMA1, -B1, -C1

Rough Alignment of RPMA1

1.Turn RPMA1 clockwise or counterclockwise until the front of the RPMA1 and projector is facing target. (See Figure 9)

1

2

Secure set screw,

then Phillips screw

from under set screw.

Figure 9

3.Tighten YAW adjustment locking screw using a #2 Phillips screwdriver.

PITCH Adjustment

1.Loosen PITCH adjustment locking screw using a #2 Phillips screwdriver. (See Figure 11)

2.Turn PITCH micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target.

3.Tighten PITCH adjustment locking screw using a #2 Phillips screwdriver.

2.Secure set screw and security Phillips screw under set screw. (See Figure 9)

Adjustments

The RPMA1 can be adjusted for rotation (yaw), vertical elevation (pitch), and horizontal tilt (roll).

2

1

3

Figure 10

YAW Adjustment

1.Loosen YAW adjustment locking screw using a #2 Phillips screwdriver. (See Figure 10)

2.Turn YAW micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target.

Figure 11

ROLL Adjustment

1.Loosen ROLL adjustment locking screw using a #2 Phillips screwdriver. (See Figure 12)

2.Turn ROLL micro-adjustment screw right or left using a #2 Phillips screwdriver until image is properly aligned on target.

3.Tighten ROLL adjustment locking screw using a #2 Phillips screwdriver.

Figure 12

7