7 : O p e r a t i n g t h e S L C X e n o n C o n s o l e
115 VAC
Connect three signal wires (Scope/Flat) from automation programmer to
2.Turn autofocus switch (Item 11 in Figure
3.Activate automation programmer for flat position. Observe that lamp focus adjustment moves lamp forward. If the lamp adjustment moves in reverse:
24 VDC
Exchange the position of the two wires.
115 VAC
Exchange the position of the two wires of
4.Turn Autofocus switch to OFF (0).
5.Obtain desired light level on screen for flat format by adjusting up/down, left/right, and forward/aft switches (Items 9 in Figure
6.Adjust flat adjustment thumbscrew (Item 18A in Figure
7.Activate automation for scope format. Set desired light level on screen for scope format by adjusting up/down, left/right, and forward/aft switches (Items 9 in Figure
8.Adjust scope adjustment thumbscrew (Item 18B in Figure
9.Turn autofocus switch to ON (1).
10.Activate automation several times between scope and flat formats to verify that autofocus adjustment moves to scope and flat settings as required.
11.Verify that light levels on screen stay at maximum or desired level for both scope and flat formats.
The lamp autofocus operates only when the autofocus switch is in the ON position. Manual lamp adjustment is possible only when the autofocus switch is in the OFF position. All autofocus adjustments must be made with the autofocus switch in the OFF position. The red and green lights do not light when the Autofocus switch is in the ON position.
CHRISTIE DIGITAL SYSTEMS | |
August 7, 2003 |
|