Cisco Systems 10000 manual Physical Interfaces and Logical Interface Technologies, Sonet

Chapter 1 Concepts

EM Objects and Interfaces

Physical Interfaces and Logical Interface Technologies

Physical interfaces and logical interface technologies are modeled as objects below a parent module. As mentioned before, the type of module characterizes the type of interface. Interface types further break down into two categories, physical interfaces and logical interface technologies.

Physical interfaces are the ports which exist on line cards. This EM supports the following physical interfaces:

•Ethernet

•SONET

•DS1

•DS3

The EM handles both SDH and SONET in the same manner. The routers support both SDH and SONET. For a comparison chart of SONET and SDH speeds, see Appendix B, “SONET/SDH Conversion Chart.”

Logical interface technologies represent the communication between two network devices. Logical interface technologies allow for virtual connections, such as PVCs and SPVCs. This EM supports the following logical interface technologies:

•ATM

•IP

•POS

Physical interfaces and logical interface technologies are classified as “interfaces” within this EM, and, therefore, are referred to as such within this guide. Keep in mind the differences previously described as you manage the interfaces within your network.

Tip The technologies an interface supports are accessible within FCAPS–based management windows. It is important to understand that physical interfaces require logical interface technologies in order to fully manage an interface.

The following table outlines each interface type and the applicable physical and logical interface technologies supported. Also included are the different FCAPS service windows that are applicable to each physical and logical interface technology. For example, if you want to configure an ATM interface type, look in the table under ATM, and you will notice that three physical interface and logical interface technologies apply: ATM, SONET, and IP. This means that to fully configure an ATM over SONET interface, for example, you should open and update the appropriate fields in all the physical and logical configuration windows to completely configure a SONET interface which supports ATM technology. Note that the shaded areas denote logical interface technologies.

Table 1-6 Physical Interfaces, Related Technologies and Windows

	Physical and Logical
Interface Type	Interface Technologies	FCAPS Service Windows
Ethernet	Ethernet	Configuration
		Status
		Performance
		Profile

IP

Configuration

Cisco 10000 Series Manager User Guide

OL-3594-01 1-11