Manuals / Cisco Systems / Kitchen Appliance / Ventilation Hood

Cisco Systems 1500 manual 5-18, Connecting Optical Cables Testing a Remote Link, 78-10588-03

Models: 1500

1 18

Download 18 pages 63.07 Kb

Page 18

5-18

Chapter 5 Connecting Optical Cables

Testing a Remote Link

	Cisco Metro 1500 Series Hardware Installation Guide
5-18	78-10588-03

Image 18

Cisco Systems 1500 manual 5-18, Connecting Optical Cables Testing a Remote Link, 78-10588-03

Contents

Connecting Optical Cables C H A P T E RConnecting WCMs to MUX and DMX Modules Figure 5-1 Connecting a WCM to a MUX and a DMX 39489Connecting BSMs with MUX and DMX Modules Connecting a BSM to a DMX Connecting a BSM to an RSM Connecting Remote Lines to a BSM Chapter 5 Connecting Optical Cables Connecting Remote Lines to a BSMConnecting Remote Lines to a BSM Direction of lightConnecting Remote Lines to RSMs Figure 5-6 Connecting Remote Lines to an RSMConnecting Local Lines to WCMs 5-105-11 Step 6 Mount the acrylic cover on the front of the chassisAttenuating Single-Mode Patch Cable Attenuating Coupler5-12 Other Limitations and Restrictions 5-13Figure 5-9 Attenuating Coupler Connecting Optical Isolators Installation Notes5-14 5-15 To connect the optical isolator, follow these guidelinesEquipment Required Testing a Remote LinkTests 5-165-17 should be on. If the modulated light does not match the clock-recovery frequency, assuming a clock recovery is installed and enabled, the R/R LED will be red. The remote receiver of the local system sees the signal and transfers it to the local transmitter. The WCM in the local system should have the L/T, L/R, R/T, and R/R LEDs onCisco Metro 1500 Series Hardware Installation Guide 5-18Chapter 5 Connecting Optical Cables Testing a Remote Link 78-10588-03