Cisco Systems 1500 manual Connecting Remote Lines to a BSM, Direction of light

Chapter 5 Connecting Optical Cables

Connecting Remote Lines to a BSM

Figure 5-5
BSM	M
M	D
M1	D1
M2	D2
M3	D3
M4	D4

Connecting Remote Lines to a BSM

D

Direction of light

39346

Step 3 Remove the dust cover from the MiniSC plug of the remote receiver fiber line, and

clean the fiber as described in the “Cleaning the Connectors” section on page 3-19.

Step 4 Remove the blind plug from the BSM connector labeled D. Connect the cleaned plug to the open connector of the BSM, as shown in Figure 5-5.

Step 5 Place the fiber-optic cables in the cable holder of the primary and extension chassis and the rack at the side of both chassis.

Note If you have an optional RSM installed, proceed to the “Connecting Remote Lines to RSMs” section on page 5-9. Otherwise skip to the “Connecting Local Lines to WCMs” section on page 5-10.

	Cisco Metro 1500 Series Hardware Installation Guide
5-8	78-10588-03