Cisco Systems 3545 MCU manual Component, Description

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU

Physical Description of the Cisco Unified Videoconferencing 3545 MCU and EMP Modules

Physical Description of the Cisco Unified Videoconferencing 3545 MCU and EMP Modules

This section provides a physical description of the Cisco Unified Videoconferencing 3545 MCU and Cisco Unified Videoconferencing 3545 EMP modules.

Physical Description of the Cisco Unified Videoconferencing 3545 MCU Module

The Cisco Unified Videoconferencing 3545 MCU module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1shows the front panel of the Cisco Unified Videoconferencing 3545 MCU module. Table 2-1describes the components of the front panel.

Figure 2-1 Cisco Unified Videoconferencing 3545 MCU Front Panel

	SERIAL	GK Reg CPU-Hight
	RST	ALARM ACT	SWAP
10/100Base T-1			RDY

157270

Physical Description of the Cisco Unified Videoconferencing 3545 EMP Module

Figure 2-2shows the front panel of the Cisco Unified Videoconferencing 3545 EMP board. Table 2-1describes the components of the front panel.

Figure 2-2 Cisco Unified Videoconferencing 3545 EMP Front Panel

	SERIAL	MC CPU-Hight
	RST	ALARM ACT	SWAP
10/100Base T			RDY

Table 2-1 Front Panel Components

157271

Component	Description
10/100 BaseT-1	An RJ-45 connector that provides the primary Ethernet connection for the IP
connector	network port.
SERIAL connector	A DB-9 connector that allows you to connect a PC terminal for local
	configuration.
RST button	Allows you to reset the board manually.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Release 5.1

2-2 OL-11899-01