Cisco Systems 4.2 Modifying VLAN Settings, Configuring VLAN Settings, Table A-5 on page A-16

Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone

Modifying VLAN Settings

Modifying VLAN Settings

You can change the administrative VLAN used by the Cisco Unified IP Phone and, on the Cisco Unified IP Phone 7905G and 7912G, you can disable or enable VLAN manually.

This section covers the following topics:

•Configuring VLAN Settings, page 4-26

•Disabling VLAN, page 4-27

Configuring VLAN Settings

If you configure an administrative VLAN manually, that setting overrides the auxiliary VLAN configured on a Cisco Catalyst switch in which the phone is a member.

To assign an administrative VLAN for the Cisco Unified IP Phone, follow these steps:

Using the Phone Configuration Web Page

Procedure

Step 1 Display the Phone Configuration web page.

For instructions, see the “Accessing Network Settings through a Phone

Configuration Web Page” section on page 4-2.

Step 2 In the pane on the left under Change Configuration, click Network Parameters.

You may be prompted to enter a password.

The Network Parameters web page appears.

Step 3 In the VLANSetting field, enter a VLAN ID into bits 18–29 and click Apply.

For more information about this field, see the VLANSetting parameter in

Table A-5 on page A-16.

	Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
4-26	OL-8617-01