Adjustment screw | Cisco Systems 4490 guide

2 Adjustment screw

Chapter 3 Installing the Cisco Global Site Selector 4490

Installing Your Unit

Figure 3-5 Attaching the Slide Rails to the Rack

Front

Rear

1

2

3

83199

1

3

Tab	2 Adjustment screw

Rear flange

7.Insert and tighten two M6 screws to secure the other slide rail assembly to the rear flange.

8.Align and insert the inner slide rails into the slide rail assemblies until they lock into place.

9.Slide the GSS 4490 into the rack until it locks into place.

		Cisco Global Site Selector 4490 Hardware Installation Guide
		Cisco Global Site Selector 4490 Hardware Installation Guide
	78-15755-01			3-9
	78-15755-01			3-9

Image 9

Cisco Systems 4490 appendix Adjustment screw

Contents

C H A P T E R Installing the Cisco Global Site Selector Unpacking and Inspecting the Global Site Selector Cisco Global Site Selector Hardware Installation Guide If the Product is Damaged Tools and Parts Required 83198 Figure 3-1 Four-Post Rack Installation Kit Installing Your Unit Figure 3-2 Installing Clip Nuts or Cage Nuts in a Non-Threaded Rack Installing the Chassis in a Four-Post Rack Slide rail assembly Figure 3-4 Attaching the Inner Slide Rail to the GSS 2 Adjustment screw Release tab 3-10 Installing the Chassis in a Two-Post Rack 3-11Cisco Global Site Selector 4490 Hardware Installation Guide Chapter 3 Installing the Cisco Global Site Selector Repeat this step to secure the left side bracket to the rack 3-12 3-13 Installing the Chassis on a Workbench or Tabletop 3-14 Connecting Cables Connecting Power Booting the System3-15 3-16 Checking the Front Panel LEDsColor State Removing or Replacing a Cisco Global Site Selector 3-17Table 3-1 Front Panel LEDs continued To physically remove a GSS 4490 from your network, follow these steps 3-18 To physically replace a GSS 4490, follow these steps 3-19 3-20