Chapter 3 Configurations for the Layer 3 Switch Router
Using the Console and the Management Ports
•Entered the command line interface (CLI) configuration mode. You do this by answering no when you are prompted to enter the initial dialog:
Would you like to enter the initial dialog? [yes]: no
You see the following user EXEC prompt:
Router>
Using the Console and the Management Ports
You can configure your Layer 3 switch router from a direct console connection to the console port or remotely through its management port.
•If you are using a direct console connection, configure your terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.
•If you are configuring remotely through the management port, you must assign an IP address to any Fast Ethernet or Gigabit Ethernet port on your Layer 3 switch router, which serves as a management port.
For interface configuration instructions, see “Configuring the Management Port” section on page
For further details on configuring ports and lines for management access, refer to the
Cisco IOS Configuration Fundamentals Configuration Guide.
Modem Support
Layer 3 switchYou can connect a modem to the console port or to the auxiliary port on the Layer 3 switch router. The following settings on the modem are required:
•Enable auto answer mode
•Suppress result codes
You can configure your modem by setting the Dual
Note Because there are no hardware flow control signals available on the console port, the console port terminal characteristics should match the modem settings.
For further details on configuring ports and modems for management access, see the Cisco IOS Configuration Fundamentals Configuration Guide and Cisco IOS Dial Solutions Configuration Guide.
Modem Support for Recovering a System Image
The Catalyst
Catalyst
| ||
|
