Cisco Systems 4908G-L3 rommon 1 dir bootflash, rommon 2 boot bootflash filename, 3-16, Command

Chapter 3 Configurations for the Layer 3 Switch Router

Updating the System Image

	Command	Purpose
Step 4
	Router# reload	Initiate a reload of the system software. You automatically
	rommon 1>	enter ROM monitor mode.
Step 5
	rommon 1> dir bootflash:	Display the contents of the file system. Perform this optional
		step to display and copy the name of the system image to the
		clipboard for use in Step 6.
Step 6
	rommon 2> boot bootflash:filename	Reboot the Layer 3 switch router with the new system image.
		You can paste the filename from the clipboard if you copied
		it in Step 5.
Step 7
	Router> show version	Display the system software version information. Use this
		step to confirm that the system is loaded with the expected
		software version.

1.For details on using the configuration register to set boot parameters, refer to the Cisco IOS Configuration Fundamentals Configuration Guide.

The following example shows how to enter terminal configuration mode, set the configuration register, save the configuration, and reload the Layer 3 switch router with the new image on the bootflash memory SIMM:

Router# configure terminal

Router(config)# config-register 0x0

Router(config)# end

Router#

4d00h: %SYS-5-CONFIG_I: Configured from console by console Router#copy system:running-confignvram:startup-configDestination filename [startup-config]?

Building configuration...

[OK]

Router# reload

Proceed with reload? [confirm]

rommon 1 >	dir bootflash:
File size			Checksum	File name
3173128	bytes	(0x306b08)	0x799f	cat2948g-in-mz.120-7.W5.14.45
3173364	bytes	(0x306bf4)	0x755f	cat2948g-in-mz.120-7.W5.14.46

rommon 2 > boot bootflash:cat2948g-in-mz.120-7.W5.14.46

Self decompressing the image : #################################################

################################################################################

################################################################################

################################################################## [OK]

<The system boots>

Router> show version

Cisco Internetwork Operating System Software

IOS (tm) L3 Switch/Router Software (CAT2948G-IN-M), Version 12.0(7)W5(14.46) IN

TERIM TEST SOFTWARE

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Tue 22-Feb-00 04:31 by

Image text-base: 0x60010928, data-base: 0x605B2000

Now that you have completed the initial configurations on your Layer 3 switch router, you can begin configuring the interfaces. For more information on reloading a Layer 3 switch router see Chapter 4, “Configuring Interfaces.”

Catalyst 2948G-L3 and Catalyst 4908G-L3 Switch Router Software Feature and Configuration Guide

3-16 78-10408-03