User Guide NetXtreme II
January 2010
Broadcom Corporation
Document ENGSRVT52-CDUM100-R Configuring Teaming Page 193
7. From the Available Adapters list, click the adapter you want to add to the team and then click Add. Remove team
members from the Team Members list by clicking the adapter and then clicking Remove. Click Next.
NOTE: There must be at least one Broadcom network adapter assigned to the team.
The TCP Offload Engine (TOE), Large Send Offload (LSO) and Checksum Offload (CO) columns indicate if the TOE,
LSO, Jumbo MTU, and/or the CO properties are supported for the adapter. The TOE, LSO, Jumbo MTU, and CO
properties are enabled for a team only when all of the members support and are configured for the feature. If this is the
case, then the team offload capabilities appear on the bottom of the screen.
NOTES:
• Adding a network adapter to a team where its driver is disabled may negatively affect the offloading capabilities
of the team. This may have an impact on the team’s performance. Therefore, it is recommended that only driver-
enabled network adapters be added as members to a team.
8. If you want to designate one of the adapters as a standby member (optional), select Use the following member as a
standby member, then choose the standby member from the list of adapters.
9. The Auto-Fallback Disable mode feature allows the team to continue using the standby member rather than switching
back to the primary member if the primary member comes back online. To enable this feature, select Enable Auto-
Fallback Disable mode. Click Next.