User Guide NetXtreme II
January 2010
Broadcom Corporation
Document ENGSRVT52-CDUM100-R Appendix A: Event Log Messages Page 59
7 Informational Network controller
configured for 10Mb full-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
8 Informational Network controller
configured for 100Mb half-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
9 Informational Network controller
configured for 100Mb full-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
10 Informational Network controller
configured for 1Gb half-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
11 Informational Network controller
configured for 1Gb full-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
12 Informational Network controller
configured for 2.5Gb full-
duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
No action is required.
13 Error Medium not supported. The operating system does
not support the IEEE 802.3
medium.
Reboot the operating system,
run a virus check, run a disk
check (chkdsk), and reinstall
the operating system.
14 Error Unable to register the
interrupt service routine.
The device driver cannot
install the interrupt handler.
Reboot the operating system;
remove other device drivers
that may be sharing the same
IRQ.
15 Error Unable to map IO space. The device driver cannot
allocate memory-mapped I/O
to access driver registers.
Remove other adapters from
the system, reduce the amount
of physical memory installed,
and replace the adapter.
16 Informational Driver initialized
successfully.
The driver has successfully
loaded.
No action is required.
17 Informational NDIS is resetting the
miniport driver.
The NDIS layer has detected a
problem sending/receiving
packets and is resetting the
driver to resolve the problem.
Run Broadcom Advanced
Control Suite 3 diagnostics;
check that the network cable is
good.
18 Error Unknown PHY detected.
Using a default PHY
initialization routine.
The driver could not read the
PHY ID.
Replace the adapter.
19 Error This driver does not
support this device.
Upgrade to the latest
driver.
The driver does not recognize
the installed adapter.
Upgrade to a driver version
that supports this adapter.
Table 8: Base Driver Event Log Messages (Cont.)Message
Number Severity Message Cause Corrective Action