Cisco Systems 7030 manual 3 4 5 6 7

Chapter 2 Camera Installation

Installing the IP Camera with a Vandal Resistant Enclosure

c.Feed the power cable through the waterproof connector (F --> E --> D --> B --> A). Be sure to feed enough power cable length through the waterproof connector to connect the power cable to the GPIO block.

(A)

(B)

(D)

(E)

(F)

Note There are 8 holes on the seal (D), and the widest holes with a crack on the side are specific for power cables.

d.Feed the I/O cables through the waterproof connector (F --> E --> D --> B --> A). Be sure to feed enough I/O cable length through the waterproof connector to connect the I/O cable to the GPIO block.

The recommended cable gauge is 2.0 ~ 2.8 mm.

e.Push the seal (D) into the housing (B).

f.Insert the seals (C) into unused holes on the seal (D) to avoid moisture.

g.Secure the sealing nut (A) tightly and hex nut (F) from the bottom of the camera.

h.Connect the power and I/O cables to the GPIO terminal block

1 2 3 4 5 6 7 8

Pin	Description
1	24 VAC
2	24 VAC
3	DI-
4	DI3+
5	DI2+
6	DI1+
7	DO-
8	DO+

Cisco Video Surveillance 7030 IP Camera Installation Guide

OL-28692-01 2-7