6
Release Notes for CPE/CS3 Switch Software Release 2.2.0.3
78-10367-01
Caveats
Resolved Caveats—Release 2.1.0.6Open Caveats — Release 2.1.0.6
Cisco MGX 8240 CPE/CS3 Switch software (Release 2.1.0.6) has some known problems. Every
attempt has been made to address and resolve the problems of high severity. The table below lists
known bugs, including all outstanding problems related to the CES modules and associated I/O ports.
The second column is the defect severity. A number 0 would represent the greatest severity while a
number 5 would be the least severe.
DDTS
Number Severity
SeveSrity
Functional
Area Problem Description Corrected
Sn05204 0 Switch
Redundancy
Redundant switchover ftp
process gives no indication to
the user when it is done.
New states
added Fixed
Sn05010 1 Alarm Two loop timed OC3 ports
connected together can cause
alarm and SNMP storm.
Alarm is
now
integrated.
Fixed
Sn05271 1 Alarm For OC3 port 2 changing from
admin state up to test does not
clear alarms. But for OC3 port 1
it does.
Alarms now
cleared Fixed
Sn05512 1 Loopback Switchresponds to DS1 far-end
line loop request by looping
errored data.
Now using
payload loop Fixed
Sn05518 1 Loopback TakingDS1 or DS3 ports out of
test does not clear the loops. Loops now
cleared Fixed
Sn05293 1 Trunk
Conditioning For SF mode robbed bit, voice
non-transparant, signalling CD
bits are not ignored.
CD Bits are
now ignored
in this mode
Fixed
DDTS
Number Severity
SeveSrity
Functional
Area Problem Description Corrected
Sn04840 1 Switch
Shaping Policing on Ascend 550
causes inband cells to be
dropped because Maximum
Burst Size (MBS) is not
configurable and fixed to
1024 cells.
Do not turn on
policing at Ascend or
set it to 1024 cells
Same as
1.1.2.10
Sn04752 3 Switch
Craft
Interface
Double ESC required to exit
from DS1 statistics window
on Craft Interface.
Same as
1.1.2.10
Sn05174 0 Xyplex FTP failed sometimes due to
Xyplex’s problem. Pending on Xyplex
new fix.
Similar problem
exists with IMC.
Same as
1.1.2.10