F-19
User Guide for CiscoWorks Small Network Management Solution
78-15693-03
AppendixF IDU Updates Other Supported Features in IDU on RME 3.5
Other Supported Features in IDU on RME 3.5
The following features are supported in IDU on RME 3.5:
•Polling Devices for Schedule Collection in Configuration Management:
You can set the options for the attribute POLL_DEVICE in the
config.properties file under
NMSROOT\www\classpath\com\cisco\nm\config\archive
to customize polling.
You can set two values for POLL_DEVICE attribute:
–
No. This is the default. When it is set to the default value, the
configurationarchive fetches running and start-up configurations even if
the MIB does not detect changes in the configuration.
–
Yes.The configuration archive fetches the corresponding configuration,
only if the MIB detects a change in the configuration.If the MIB does not
detectany change in the configuration, the configuration archive does not
fetch the running or start-up configurations.
You must restart the daemons after setting the values of POLL_DEVICE
attribute to reflect the changes.
•Support for Network Analysis Module (NAM) devices:
–
NetConfig: Support for system-defined configuration templates like
TACACS+ template, Syslog template, SNMP Traps template, DNS
template, WebUser template, SNMP Community template, Ad-hoc
template, and user-defined Protocol template.
For more details, see Online Help:Resource Manager Essentials >
NetConfig > Configuration Templates.
–
NetShow: Support for NAM commands.
For more details, see Online Help: Resource Manager Essentials >
Network Show > The Basics > List of Network Show Commands >
Network Show Commands for Network Analysis Module.
–
Config Editor: Supports NAM as a new category of device.
•NRP2 distribution performed through the parent NSP device.
For more details, see Online Help:Resource Manager Essentials >
Software Management >Distribution >Distribute by Devices.