To install the Cisco Unified IP Phone Expansion Module 7915, perform the following tasks.
1.Remove the Footstand from the Cisco Unified IP Phone.
2.Connect the Support Bar to the Cisco Unified IP Phone.
3.Connect the Expansion Module 7915 to the Support Bar.
4.Connect the Interface Cable.
5.Connect the Power Supply Unit.
6.Connect the Footstand.
7.Connect a Laptop Cable Lock (optional).
Refer to the detailed instructions and corresponding illustrations that follow for each of these
Caution To ensure a successful installation, verify with your system administrator that your phone is ready for the Cisco Unified IP Phone Expansion
Module 7915 and that Cisco Unified Communications Manager is installed and configured for the Cisco Unified IP
Phone Expansion Module 7915. Make sure that you have all of the parts that you need (see the “Before You Begin” section on page 3).
Remove the Footstand from the Cisco Unified IP Phone
Refer to Figure 2 and the steps that follow.
7
