Cisco Systems 7960G manual Network Configuration

Chapter 7 Monitoring the Cisco Unified IP Phone Remotely

	Network Configuration
Table 7-1 Device Information Area Items (continued)
Item	Description
Phone DN	Directory number assigned to the phone
App Load ID	Identifier of the firmware running on the phone
Boot Load ID	Identifier of the factory-installed load running on the
	phone
Version	Version of the phone hardware
Expansion Module 1	Phone load ID for the first Cisco Unified IP Phone
	7914 Expansion Module if connected to the phone
Expansion Module 2	Phone load ID for the second Cisco Unified IP Phone
	7914 Expansion Module, if connected to the phone
Hardware Revision	Version of the phone hardware
Serial Number	Serial number of the phone
Model Number	Model number of the phone
Codec	Codec used by the phone
Amps	Indicates whether 3 volt or 5 volt amplifier is being
	used by the phone
C3PO Revision	Revision of the Cisco 3 port switch in the phone
Message Waiting	Indicates if there is a voice message waiting on any
	line for this phone

Network Configuration

The Network Configuration area on a phone’s web page displays network configuration information and information about other phone settings. Table 7-2describes these items.

You can view and set many of these items from the Network Configuration Menu the Cisco Unified IP Phone. For more information, see Chapter 4, “Configuring Settings on the Cisco Unified IP Phone.”

To display the Network Configuration area, access the web page for the phone as described in the “Accessing the Web Page for a Phone” section on page 7-2, and then click the Network Configuration hyperlink.

	Cisco Unified IP Phone 7940G/7960G Administration Guide for Cisco Unified CallManager 4.2(3)
OL-8555-02		7-5