Chapter 3 Setting Up the Cisco Unified IP Phone

Adjusting the Placement of the Cisco Unified IP Phone

See Figure 3-3for a graphical representation of the phone parts.

Before You Begin

To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook from the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip on which the handset catches when the phone is vertical. For an illustrated procedure, refer to Installing the Wall Mount Kit for the Cisco Unified IP Phone at:

http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guides_list.html

To mount the phone on the wall using the standard footstand, follow these steps:

Caution Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.

Procedure

Step 1 Push in the footstand adjustment button.

Step 2 Adjust the footstand so it is flat against the back of the phone.

Step 3 Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand. The keyholes fit standard phone jack mounts.

Step 4 Hang the phone on the wall.

Figure 3-3 Parts Used in Wall Mounting the Cisco Unified IP Phone

1

2

3

Footstand adjustment button—Raises and lowers adjustment plate

Wall mounting screw holes

Adjustment plate—Raises and lowers phone vertically

 

 

Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 7.0

 

 

 

 

 

 

OL-15427-01

 

 

3-11

 

 

 

 

 

Page 11
Image 11
Cisco Systems 7945G, 7965G manual Before You Begin, Parts Used in Wall Mounting the Cisco Unified IP Phone