Chapter 1 Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide
Connect the Power-over-Ethernet Module to the Cisco 870 Series Router (Optional)
Connect the Power-over-Ethernet Module to the Cisco 870 Series Router (Optional)
Power-over-Ethernet (PoE) is supported on the Cisco 870 Series routers only. If you purchased a PoE module, connect all four Ethernet cables on the PoE module to the four LAN Ethernet ports on the Cisco 870 Series router. (See Figure 1-5.) Make sure that you connect all four Ethernet cables.
If the cables are too close together for easy insertion, move the plastic cable guard away from the connector end of the cables.
Caution To ensure proper PoE module operation, do not connect the PoE module power supply to the PoE module before you connect the PoE module to the router.
Although Figure 1-5shows the Cisco 871 router connected to a PoE module, this connection works for all router models in the Cisco 870 series.
Note When you connect a device (such as a PC or IP phone) to the PoE module, you may notice a 1- to 2-second delay before the LED indicator for the port comes on.
| Cisco 850 Series and Cisco 870 Series Access Routers Cabling and Setup Quick Start Guide |
1-10 | 78-16262-04 |
