Cisco Systems 8xDMT Monitoring and Maintaining the 8xDMT Line Card

Octal-Port DMT ATU-C Line Card

Monitoring and Maintaining the 8xDMT Line Card

Cisco IOS Release 12.1(6)DA

Cisco provides Cisco.com as a starting point for all technical assistance. Customers and partners can

obtain documentation, troubleshooting tips, and sample configurations from online tools.

For Cisco.com registeredusers, additional troubleshooting tools are available from the TAC website. To

obtain troubleshooting help, go to the Cisco Troubleshooting Assistant web site on Cisco Connection

Online (CCO) at:

http://www.cisco.com/kobayashi/support/tac/tsa/dslstep.html

Also see the “Monitoring and Maintaining the 8xDMT Line Card” section on page 8.

Monitoring and Maintaining the 8xDMT Line Card

Use the following commands to monitor and maintain the 8xDMT line card:

Step3 DSLAM(config-dsl-profile)# dmt

check-bytes fast downstream 0 upstream 0 Set the upstream and downstream FEC check (redundancy)bytes

to 0.

Step4 DSLAM(config-dsl-profile)# dmt margin

downstream 12 upstream 6 Set the downstream and upstream signal-to-noise ratio (SNR)

margins for a DSL profile.

Step5 DSLAM(config-dsl-profile)# dmt

overhead-framing mode1 Set the overhead framing mode, in this example to 1.

Step6 DSLAM(config-dsl-profile)# exit Return to the global configuration prompt.

Command Purpose

DSLAM# show dsl interface atm s

lot/port

DSLAM# show dsl status DMT

These commands display basic information about the DSL link,

including port status, dsl statistics, line errors, and cards detected.

DSLAM# show facility-alarm status The show facility-alarm status command displays all of the current

major and minor alarms and the user-configurable alarm thresholds

for temperature. After an alarm condition is indicated (by LEDs or

bells), you can use the show facility-alarm status command to

determine the cause of the alarm.

Note You must turn on the alarms in the profile for alarms to

be displayed.

DSLAM# show hardware Theshow hardware command shows information on each of the

slots in your chassis. It tells whether line cards, fan trays, and PEMs

are present.