Configuring Token Ring Inter-Switch Link

TRISL Configuration Examples

TRISL Configuration Examples

The following sections provide TRISL configuration examples:

IP Routing Non-Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example, page 155

IP Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example, page 156

IP Routing Source-Route Frames Between a TRISL VLAN and an Ethernet ISL VLAN Example, page 157

IP Routing Source-Routed Frames Between TRISL VLANs Example, page 158

IPX Routing Non-Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example, page 159

IPX Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example, page 160

IPX Routing Source-Route Frames Between a TRISL VLAN and an Ethernet ISL VLAN Example, page 161

IPX Routing Source-Routed Frames Between TRISL VLANs Example, page 162

SRB Between Token Ring and TRISL VLAN Example, page 163

SRB Between TRISL VLANs Example, page 164

Transparent Bridging Between Token Ring and TRISL VLAN Example, page 166

SR/TLB Between a TRISL VLAN and an Ethernet Interface Example, page 167

SR/TLB Between a TRISL VLAN and an Ethernet ISL VLAN Example, page 168

TRISL with Fast EtherChannel Example, page 169

Note Because the VLAN Trunk Protocol (VTP) is not supported on the router configured with TRISL, the TrCRF configuration on the router must also be specified in the Catalyst 5000 switch configuration.

 

Cisco IOS Bridging and IBM Networking Configuration Guide

BC-154

78-11737-02

Page 10
Image 10
Cisco Systems BC-145 manual Trisl Configuration Examples, BC-154