Installing the SP Bootflash Memory Upgrade Kit
Figure 3 Removing the Module from the Chassis (Horizontal Chassis Shown)
1
2
3
4
5
48 10/100 NG
o
o
INPUT | FAN OUTPUT |
OK | FAIL |
INPUT | FAN OUTPUT |
OK | FAIL |
91526
Installing the CompactFlash Adapter
To install the CompactFlash adapter, follow these steps:
Step 1 Locate the SP BOOTFLASH DIMM socket on the Supervisor Engine 720. (See Figure 4.) The SP BOOTFLASH DIMM is on the left side of the Supervisor Engine 720 as you face the front of the board; the RP BOOTFLASH DIMM is on the right side of the Supervisor Engine 720 as you face the front of the board.
Note The DIMM is a sensitive component that is susceptible to ESD damage. To prevent ESD damage, wear an ESD grounding wrist strap and handle the DIMM by the edges only; avoid touching the memory modules, pins, or traces (including the metal fingers along the connector edge of the DIMM). Attach an ESD grounding strap to your wrist and to ground. (If you are unsure about the correct way to attach an ESD grounding strap, see the “Attaching Your ESD Grounding Strap” section on page 24 for instructions.)
Cisco CompactFlash Adapter for Bootflash Upgrade Installation Note
| 13 |
| |
|
|