Removing and Installing the CompactFlash in the CompactFlash Adapter
Figure 11 Removing the CompactFlash from the Adapter
1 | 2 | 3 |
Cisco Systems
Cisco Systems
144747
To install the CompactFlash in the adapter, follow these steps:
Step 1 Remove the replacement CompactFlash from its packaging.
Step 2 Grasp the empty adapter and the CompactFlash, and position the CompactFlash in front of the adapter as shown in Figure 12, View 1. Align the slots in the CompactFlash with the rails in the adapter.
Step 3 Slide the CompactFlash into the adapter until the CompactFlash is firmly seated in the adapter connector. (See Figure 12, Views 2 and 3.)
Note To make good electrical contact, you must fully insert the adapter’s connector pins into the CompactFlash; the pins should not be visible.
Step 4 Install the CompactFlash adapter in the DIMM socket using Step 6 and Step 7 on Page 15.
Step 5 Reinstall the Supervisor Engine 720 in the chassis following the “Reinstalling the Supervisor Engine 720” procedure on page 16.
Cisco CompactFlash Adapter for Bootflash Upgrade Installation Note
| 23 |
| |
|
|
